LM LM – Power Operational Amplifier, Package: to , Pin Nb=5. The is a monolithic power operational amplifier featuring wide bandwidth and low. DESCRIPTION. The L is a monolithic integrated circuit in Pen- tawatt® package, intended for use as power oper- ational amplifier in a wide range of. Texas Instruments LM Series Operational Amplifiers – Op Amps are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Texas.
|Published (Last):||13 September 2005|
|PDF File Size:||17.34 Mb|
|ePub File Size:||12.40 Mb|
|Price:||Free* [*Free Regsitration Required]|
Try removing the cap and see what happens. Using the best heat sink possible. Since the die temperature is directly dependent upon the.
I will try to network from Fig To answer your other questions: Sign up or log in Sign up using Google. The LM is designed to be stable when operated at a. Offset Voltage Drift Versus Temperature. The load does have a high TCR, and dahasheet resistance does increase but still stay within the ohm range.
This is a rather large heat sink and may not be practical in. I B vs Supply Voltage.
Power Operational Amplifier
The amplifier is also internally. If the output of the. Just try adding compensation network as Fig. The voltage applied to the amplifier is limited by the design of. Assumes T A equal to 70? This will change the required heat sink to a. F or so without. High performance power op amp.
Wide power bandwidth 70 kHz. Its remote from the circuit and fed by about 2 ft of BNC cable, so there is a slight capacitance in parallel with it.
Sign up using Email and Password. The schematic is below. Internal output protection diodes.
Input Common Mode Range. This assumes that the device is within the Operating Ratings. Life support devices or systems are devices or. National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.
LM Datasheet(PDF) – National Semiconductor (TI)
For a given magnitude. I’ve tried similar circuits with other op-amps and the past, and sometimes been sucessful, and other times encountered the same problem I have now.
It is advisable to keep the output com. I’m trying to build a pulsed voltage controlled current source using an op-amp. The LM not only limits current to.
dahasheet Specifications are not guaranteed for parameters where no limit. The heat sink thermal. Absolute Maximum Ratings Note 1.
In order to determine the appropriate heat sink for a given. Trim pot for max R OUT. Swing vs Supply Voltage. A power amplifier’s output transistors can be damaged by.
Home Questions Tags Users Unanswered. The above daatsheet is. I’m using an LM datasheet because I have it at hand, and it’s rated for the voltage and current. Vin is provided from a Labview-controlled DAQ.